Korg X5DR AI2 SYNTHESIS MODULE Owner's Manual page 114

0A, 0B Program Select
These parameters allow you to assign Programs to Timbres.
Timbres 1–4
00A PROGRAM 1-4ø
A00 A01 A02 A03
0A
LCD Parameter
0A Timbre 1–4 Program Select
0B Timbre 5–8 Program Select
Here you can select a Program for each Timbre.
The Timbre that is set to "OFF" will not sound.
A Program must be selected from Bank A and G.
Incoming Program Change messages will select Programs for Timbres
of the corresponding channel.
However, if the MIDI channel of the received Program Change is the
same as the Global MIDI channel of the X5, the Combination will
change.
To avoid changing the Combination via MIDI, set the 2C MIDI FILTER
PRG in the Global Mode to "PRG". To change only the number, without
changing the bank, set the Program to "NUM".
To see how the various timbres correspond to the MIDI Bank Select and
Program Change functions, please refer to the related section on
page 66, 68, 77, 104, 153 and 172.
1A, 1B Level
These parameters allow you to set the volume level of each Timbre in a Combination.
Timbres 1–4
01A LEVEL 1-4 ø
127 099 011 127
1A
LCD Parameter
1A Timbre 1~4 Level
1B Timbre 5–8 Level
With a value of 127, the volume uses the level setting of the Timbre program parameter. With a
value of 0, no sound is output.
The volume level is determined by this parameter multiplied by the value set for MIDI Volume
Controller No. 7, or Expression Controller No. 11.
Timbres 5–8
ø
00B PROGRAM 5-8
A04 G01 G99 128
0B
Range
OFF, A00–A99
G01–136
Timbres 5–8
ø
01B LEVEL 5-8
055 127 127 127
1B
Range
0–127
Description
Assign a Program to a Timbre
Programs available
Description
Sets the volume level of each Timbre
Reference Guide
Internal
Bank A
100 Combi
100 Prog
Bank G
136 Prog
2
COMBINATION
Parameters
101