Table of Contents
Advertisement
955_00_1ATT CIB
#change
Hold
Press and release H. The light of the line on hold flashes, and a
double-beep sounds every 30 seconds to remind you the call is on hold.
(To turn off the reminder beep, see "Turn Hold Reminder On or Off" in SET
UP SYSTEM FEATURES.) You can replace the handset in the cradle without
disconnecting the call. The speakerphone is automatically turned off.
To release Hold, press and release the LINE button of the call on hold.
NOTE: The system automatically disconnects a call on hold after 20
minutes. To keep a call on hold longer than 20 minutes, release Hold
before 20 minutes and then place the call on hold again.
NOTE: You cannot put an intercom call on hold.
NOTE: If a line is in use, pressing I or p will place the line on
hold and activate the intercom.
Switch Between Lines
1
Press and release H to keep a call on the first line.
2
Press and release the LINE button of another line to make or
answer another call.
NOTE: If you switch lines without pressing H first, you will drop the call.
Mute
This feature lets you mute the telephone so that you can hear the other
party, but the other party can't hear you.
To activate this feature, press and release M. The MUTE light goes on.
To return to the conversation, press and release M again.
NOTE: Switching from handset to speakerphone or headset, or from
speakerphone or headset to handset, changing lines, and putting a call on
hold also cancel Mute.
Flash
Use F instead of the switchhook to activate telephone company
subscriber services such as Call Waiting or Three-Way Calling.
To adjust the length of the Flash signal, see "Set the Flash Time" in SET UP
SYSTEM FEATURES.
10/24/02
9:48 AM
TELEPHONE OPERATION
Page 27
27
Advertisement
Table of Contents
