Switch Identifiers - Lucent Technologies MERLIN LEGEND Release 6.0 Network Reference Manual

MERLIN LEGEND Communications System Release 6.0
Network Reference 555-660-150
5 System Management

Switch Identifiers

Programming Instructions
Console Procedures
PC Procedures
Switch Identifiers
If your system uses private tandem trunks, you must program switch identifiers.
Switch identifiers are 1- or 2-digit numbers that are used by the system to identify
transmission levels and check routing. Switch identifiers indicate the switch
connected to the far end of a local private trunk.
Switch identifiers appear in print reports. You can use Next to see the switch
identifiers for all trunks. To see a report showing switch identifiers, select the
Q…v‡
option on the System Programming menu and then choose
Brr…h
and
report. The switch identifier appears in the "Extern Switch" column.
Planning Guidelines
The procedures in this topic allow you to add, change, and remove switch
identifiers.
PSTN trunks connected to your local system do not require identifiers. They are,
by default, not assigned an identifier.
When a private networked trunk is deleted, either via DS1 programming or by the
Board Renumber procedure, all switch identifiers in the system need to be
examined and reprogrammed as needed. Newly added private network trunks
need to be programmed with new switch identifiers.
To specify new extension ranges:
extension in range
range
range
To delete extension ranges:
extension in range
Ä Æ
To specify new extension ranges:


range
 Ç Ç Ç
range
range
Ä Æ
To delete extension ranges:
  Ç Ç
l. See Appendix B for an example of the General Trunk Information
5
Dial no. of last extension in
Dial no. of pattern for extension
Type no. of first extension in
Type no. of last extension in
Type no. of pattern for extension
Type no. of first extension in range
5
5
Issue 1
February 1998
Page 5-13
Dial no. of first
Dial no. of first
ÃU…ˆxÃvs‚