MERLIN LEGEND Communications System Release 6.0
Network Reference 555-660-150
3
Feature Interactions
Calling Restrictions
MLX display telephone. The factory setting for Remote Call Forwarding is to
prohibit it for all extensions, so the system manager must program the original
receiving extension to allow use of the feature.
Remote Call Forwarding is activated by specifying a tandem PRI trunk and the
number of the non-local extension, for example, ""Ã (Remote Call Forwarding
feature code) or programmed Forward button, plus
number), plus
remote access via the network allows a user to change the forwarded-to
destination for a non-local extension.
!
WARNING:
To prevent toll fraud, it is recommend that a tandem pool should not be used
for Remote Call Forwarding.
Calling Restrictions
Outward restrictions, toll restrictions, Allowed/Disallowed Lists, Night Service
restrictions, Extended Station Status restrictions, and the prohibition of trunk-to-
trunk transfers do not apply to calls made to extensions in the non-local dial plan.
These restrictions are still active for other calls.
To prevent toll fraud, dial-access to pools must not be permitted for pools of
private network trunks.
!
Camp-On
Camp-On does not work for calls at non-local dial plan extensions.
"! !Ã (non-local extension number), plus Æ . However, dialing into
Ã
CAUTION:
Unless networked systems are collocated, each system should have
at least one loop-start line connected to the PSTN. The line is
required to allow connection of a power-failure telephone to the
Power-Failure Transfer (PFT) jack on a module as a power outage
backup and for correct routing of emergency and other N11 calls. To
ensure that the correct services are reached, if the loop-start line is
used for emergency or other N11 calls, it should be assigned to the
main pool. In this case, IXC calls determine the number of loop-starts
required. Refer to Feature Reference guide for details on the PFT
feature.
' Ã (tandem PRI trunk
Ã
3
3
Issue 1
February 1998
Page 3-5
Need help?
Do you have a question about the MERLIN LEGEND Release 6.0 and is the answer not in the manual?