Scenario 3: Facilities Planning, Calls Originating Within The Network And Going To The Pstn - Lucent Technologies MERLIN LEGEND Release 6.0 Network Reference Manual

Communications system
Hide thumbs Also See for MERLIN LEGEND Release 6.0:
Table of Contents

Advertisement

Table 2–14. Scenario 3: Facilities Planning, Calls Originating within the Network and Going to the PSTN
System J: Cambridge,
Component
MA (Area Code: 617)
Not applicable for analog
DS1 Switch Type
tandem tie trunks
22 for a system within 200
Switch
miles (System K)
Identifiers
Programmed on
This System
ARS Access Code
9
Remote Access Code: 889*
Remote Access
Code and COR
All-tie and all non-tie
for UDP and
Toll Restricted
Barrier Code Required
ARS Routing via
FRL=3
This System
*
These are the factory settings. The remote access COR settings are not used for controlling ARS calling on PSTN facilities connected to this
system. Such calls are not routed to this system.
Local considerations may require a lower (more restrictive) FRL
.
System K: Boston, MA
System L: Washington,
(Area Code: 617)
DC (Area Code: 202)
MERLIN LEGEND-PBX
MERLIN LEGEND–Ntwk
21 for a system within 200
02 for a system more than
miles (System J)
200 miles away (System K)
03 for a system more than
04 for a system more than
200 miles away (System L)
200 miles away
(System M)
9
9
Remote Access Code: 289
Remote Access Code: 389
All non-tie and all tie
All non-tie
Outward Unrestricted
Outward Unrestricted
Barrier Code Required
Barrier Code Required
(ignored for UDP extension
(ignored for UDP extension
and non-local ARS calls)
and non-local ARS calls)
Disallowed List 7
Disallowed List 7
FRL=4
FRL=6
System M: Raleigh, NC
(Area Code: 919)
MERLIN LEGEND-PBX
03 for a system more than
200 miles away (System L)
9
Remote Access Code: 489
All non-tie
Outward Unrestricted
Barrier Code Required
(ignored for UDP extension
and non-local ARS calls)
Disallowed List 7
FRL=6

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MERLIN LEGEND Release 6.0 and is the answer not in the manual?

Table of Contents