Input Selection; Test Pattern; Lookup Tables - Barco MIVD 1218 User Manual

3 Turn the control wheel to select one of the categories: Input
selection, Test Pattern, Synchr. Sampl, Lookup Tables, Filter,
Power Led, ALC active, or de-interlacing.
4 Click the control wheel to enter the selected settings menu.
5 Turn the control wheel to change the setting.
6 Click the control wheel to confirm the change.

Input Selection

This setting allows you to define how the display will determine which
input to select: Analog (composite video input) or DVI.
These are the possibilities:
Automatic .................If Automatic is selected, the selection of the
Analog ......................When on, the analog video input is selected.
DVI ...........................When on, the DVI input is selected.

Test Pattern

The display contains an internal grayscale test pattern. Switch it on in
case you want to do a quick visual check on the display quality.
A check mark ( ) means it is switched on, a cross ( ) means it is off.
Note: The test pattern runs independent from the signal input and the
actual scan mode.

Lookup Tables

This setting allows you to select a lookup table for the current scan
mode.
You can select the following lookup tables:
Panel ........................Select a panel lookup table in case the graphic
User manual MIVD 1218
input is determined according to the following
priority: 1) DVI input, 2) BNC inputs
A check mark ( ) means On, a cross ( )
means Off.
Consequently, the Automatic setting will be
switched off.
A check mark ( ) means On, a cross ( )
means Off.
Consequently, the Automatic setting will be
switched off.
A check mark ( ) means On, a cross ( )
means Off.
board that generates the video signal already
provides gamma correction, a display function
or a non-linear lookup table.
22