Overview Of Commands; Input Selection Commands; Inp - Barco MDSC-1119 Manual

Most commands are available with the type CMD, RV, Mm, and MM. However, as the
table at the end of this document shows some may only be valid at certain types. An
example of this is the "INPN" command, which reads the name of the input and is read
(RV) only. If the command type is sent for a command which is not available an error
message will be returned.
4.

Overview of Commands

Input Selection commands

4.4.
The following commands give you comparable to control as with the Input Selection
menu in the OSD.

INP

4.4.1.
This command can be used to select an input. The input corresponding to each number
depends on the configuration of the display and can be determined by the read (RV)
command. Unlike the OSD all inputs, even disabled ones can be selected.
Command
CMD
RV
INP
MM
Mm
CMD
•
Selects the input and returns with the input name
Example: CMD,INP,1
Response: VGA
RV
•
Reads the currently selected input name.
Example: RV,INP
Response: VGA
MM
•
Returns the maximum input number.
Example: MM,INP
Response: 13
Mm
•
Returns the minimum input number.
Example: Mm,INP
Response: 1
MDSC-1119 and MDSC-2124 _________________________________________________________________ 10
Input Type
1 – max number of inputs available
Overview of Commands