Filter; Power Led; Alc Active; Dpms - Barco MIVD 1218 User Manual

DICOM .....................Select a DICOM lookup table for most medical
CRT ..........................Select a CRT (gamma) lookup table in case the
Apart from these factory lookup tables, there is a User programmable
lookup table. It is default filled out with the DICOM lookup table
(dedicated software needed to re-program it).

Filter*

* Not in DVI mode
The display electronics provide 4 different low-pass filters to filter
possible high-frequent distortion from an analog video signal.
Select a different filter in case the image contains high-frequent noise
or distortion. Select the filter that gives the best result.
Re-calibration of the phase is necessary after selection of a different
filter.

Power Led

This setting allows you to switch off the power LED.
A check mark ( ) means it is switched on, a cross ( ) means it is off.
Note:
The LED's orange DPMS state is not influenced by this setting. So,
when the display goes into power-saving mode, the LED will turn
orange, even if it was switched off by this setting.

ALC active

This setting allows you to switch ALC (Ambient Light Compensation)
off or on.
The ALC system automatically adapts the display light output,
depending on the ambient light in the room. The ambient light is
measured by the ALC optical sensor located at the front of the
display.
DPMS active
This setting allows you to switch DPMS (Display Power Management
System) off or on
Orientation**
** Only when Portrait Accelerator is installed
Select the desired option:
User manual MIVD 1218
viewing applications. The DICOM function
results in more visible grayscales in the images.
display is used to replace a CRT display.
23