Rack Mount Kit - Fluke 8508A User Manual

Introduction
A Rack Mount Kit for mounting the Multimeter in a standard 19-inch equipment rack is
available as an Option.
For instructions on how to install the kit and mount the Multimeter in the equipment rack
refer to Figure B-1 and the following procedure. The numbers in the drawing relate
directly to the numbers in the procedure.
Do not remove the top or bottom cover to rack mount the Multimeter.
1. Remove each of the two rear corner blocks by first removing their three hex screws.
2. With the corner blocks removed, re-install the top and bottom screws from each
corner block. These screws secure the Multimeter's top and bottom covers.
3. Slide out and remove the side-cover-strips from the Multimeter.
4. Attach each front rack-mount ear as follows:
a. With the front rack-mount ear parallel to the front panel and extending away
from the Multimeter, slide its extension into the Multimeter's side cover-strip
opening.
b. Secure the rack-mount extension (side cover-strip opening) to the Multimeter
using the three hex screws provided with the kit..
5. Remove the four feet and the two tilt-stands as follows:
a. Use a flat blade screwdriver to press the tab in the recess of the foot moulding,
this allows the part to be removed.
b. Store safely for possible future use.

Rack Mount Kit

Note
Appendix B
B-1