Altigen AltiWare OE/ACC Version 5.0A Administration Manual page 263

Parameter
Incoming
sequence
Or
Use This Trunk
as Mobile Trunk
Apply to...
Note:
In order for back-to-back T1/E1 and tie trunk T1/E1 configurations
to perform properly, it is recommended that you use the system's
default incoming call sequences:
AltiWare OE System Installation & Administration Manual
Description
Select up to five incoming symbols to collect from the
Caller ID or DID digits:
• None
• #
• *
• # or *
• Caller ID
• DID/DNIS
Selecting 'None' in any field of the sequence will terminate
the sequence and automatically disable subsequent entries
in the sequence.
The default sequence is:
"# or *" Caller ID"
(and then) "
DID/DNIS"
then) "
Sets up an additional, alternative sequence. You can select
another set of up to five incoming symbols to collect.
Not checking any box is equivalent to checking 'None' in
the first field.
The default sequence is:
"DID/DNIS"
When enabled, this trunk will be used as a mobile trunk for
mobile extension use. Refer to "Alti-Mobile Extensions"
on page 15-1 for more information.
If appropriate, you can use this button, as described in
"Configuring One or Multiple Trunks" on page 7-3, to
apply the Caller ID Collection to multiple T1 trunks.
Trunk Configuration
# or *"
(and then) " (and
7-25