Auto Print Head Check Selection; Centronics Interface Ack/Busy Timing Selection - TEC SX4T - B B/W Direct Thermal User Manual

5. SYSTEM MODE

5.4.17 Auto Print Head Check Selection

With this parameter you can select whether or not the Auto Print Head Check function is
activated at the power on time. When "<2>PARAMETER SET" appears, press the [PAUSE] key
and the [FEED] key 16 times.
Press the [PAUSE] key to start. Use the [FEED] or [RESTART] key to select a desired option.
[RESTART]
[FEED]
NOTES: 1. It will take about 2 seconds to perform the Auto Print Head check.
2. It is recommended that this function is turned on when high quality printing such as
bar codes printing is required, otherwise turned off.
After selecting the auto print head check, press the [PAUSE] key.

5.4.18 Centronics Interface ACK/BUSY Timing Selection

With this parameter you can select the ACK/BUSY timing of the Centronics interface.
When "<2>PARAMETER SET" appears, press the [PAUSE] key and the [FEED] key 17 times.
Press the [PAUSE] key to start. Use the [FEED] or [RESTART] key to select a desired option.
[RESTART]
[FEED]
After selecting the ACK/BUSY timing, press the [PAUSE] key.
Auto print head broken element check is not
performed.
Auto print head broken element check is
performed.
5-28
EO18-33012A
5.4 PARAMETER SETTING