Installation Procedure For Optional Equipment - TEC SX4T - B B/W Direct Thermal User Manual

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT

4. INSTALLATION PROCEDURE FOR OPTIONAL
EQUIPMENT
1. Make sure to unplug the power cord before installing the optional equipment.
2. Be careful not to pinch your fingers or hands with the covers.
The following optional equipments are provided for this printer.
B-4205-QM:
B-8204-QM:
B-9904-H-QM:
B-9904-R-QM:
In this section, installation procedures for these optional equipments are described.
NOTES:
1. The B-4205-QM, B-8204-QM, and B-9904-H-QM cannot be used together.
2. The B-9700-LAN-QM and the B-9700-USB-QM cannot be used together.
3. When using the B-9700-PCM-QM together with the B-9700-LAN-QM or the B-9700-USB-QM, attach the
B-9700-PCM-QM onto the Main PC board.
4. The strip module, ribbon saving module, and expansion I/O interface board are standard on the B-SX5T
series.
5. When installing the B-4205-QM swing cutter module or B-8204-QM rotary cutter module on the B-SX5T
series, it is necessary to remove the strip sensor, rewinder harness, rewind full sensor harness,
expansion I/O interface board, etc. Follow the procedure below.
1) Turn the power off and disconnect the power cord.
2) When the printer is used in the batch or strip mode:
Remove the two black screws to detach the front plate.
NOTE: Retain the two black screws and front plate.
When the printer is used in the built-in rewinder mode:
Open the top cover, remove the two SMW-4x8 screws, and detach the rewinder guide plate
from the printer.
Rewinder Guide
Plate
SMW-4x8
Swing Cutter
Rotary Cutter
Strip Module
Ribbon Saving Module
4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
WARNING!
B-9700-PCM-QM: PCMCIA Interface Board
B-9700-LAN-QM:
B-9700-USB-QM:
B-7704-IO-QM:
SMW-4x8
4- 1
LAN Interface Board
USB Interface Board
Expansion I/O Interface Board
Black Screws
EO18-33012A