Service Mode - Hayward Pro Logic® Installation Manual

• The display will periodically indicate that the filter pump is on for heater cooldown and show the minutes
remaining.
• The pump will automatically turn off at the end of the 5 minute heater cooldown period.
For more detailed instructions on control and operation of the Pro Logic system, refer to the Operation Manual.

Service Mode

Service mode disables all automatic control operation and is intended to be used when servicing the pool system.
To enter service mode, push the SERVICE button once on the main unit keypad. This will initially turn all outputs
off and then allow you to turn outputs on/off manually at the main display (only). In service mode, the buttons on
the optional remote display/keypad and the optional spa side remote will turn outputs off, but will not turn any
output on. Heater control outputs and solar control outputs are prevented from turning on if the water temperature
exceeds 104ºF (40ºC).
Pushing the SERVICE button again will enter a timed service mode. Service operation as described above will
continue for 3 hours, then automatically return to normal operation.
Push the SERVICE button once more to exit out of Service mode.
42