Maintenance Menu - Hayward Pro Logic® Installation Manual

if any output is configured as a
variable speed pump
VSP Speed
%
This is the unit of measure for displaying the speed of the variable speed pump. Select % of maximum
speed (3450 RPM) or revolutions per minute (RPM).
if ColorLogic Network Module is detected
Reset ColorLogic to
Default Press +
Are you sure?
+ to proceed
ColorLogic. reset
Confirmed
Use this function to erase all ColorLogic configuration settings and reset back to the factory default
values. This function is NOT reversible--be careful.
Reset Config. to
Default Press +
Are you sure?
+ to proceed
Config. reset
Confirmed
Use this function to erase all previous system configuration settings and reset all configuration
parameters back to the factory default values. This function is NOT reversible--be careful.

Maintenance Menu

The Maintenance Menu will be displayed only if the optional AQL-CHEM is used and the Sensing System is
enabled in the Chemistry Config. Wizard. This menu is used to perform functions relating to the AQL-CHEM ORP
and pH sensing kit.
pH Calibration
Wizard, + to enter
Use this Wizard to calibrate the AQL-CHEM's pH probe. This requires a manual pH test of the pool
water using a dependable red phenol test kit.
Clean Probe Wizard
+ to enter
Use this Wizard to clean the AQL-CHEM's ORP and pH probes. The probes must be clean and free
from oil, chemical deposits and contamination to function properly. Slow response, increased need to
calibrate, and inconsistent readings are indications that the probes need to be cleaned.
Toggle between % and RPM
Move to previous/next configuration menu
Initiate reset of ColorLogic configuration parameters
Move to previous/next configuration menu (config. not reset)
Reset all configuration parameters
Move to previous/next menu (config. not reset)
Move to previous/next configuration menu
Initiate reset of all configuration parameters
Move to previous/next configuration menu (config. not reset)
Reset all configuration parameters
Move to previous/next menu (config. not reset)
Move to previous/next configuration menu
(only displays if Sensing System is enabled)
Push to access pH Calibration Wizard
Move to previous/next menu item
Push to access Clean Probe Wizard
Move to previous/next menu item
40