Figure 1-12 Removing And Replacing The Front Cover - HP rp4410 Installation Manual

Installing the System
Installing Additional Components

Figure 1-12 Removing and Replacing the Front Cover

Step 4. Raise the cover slightly, and pull the cover toward the front of the server to free the tabs from the
slots in the center of the chassis.
Replacing the Front Cover
To replace the front cover, follow these steps:
Step 1. Align the tabs at the rear of the front cover with the corresponding slots in the chassis and fully
seat the tabs into the slots.
Step 2. Tighten the four thumbscrews securely.
Step 3. Replace the front bezel. (See "Replacing the Front Bezel" on page 29.)
Removing the Top Cover
To remove the top cover, follow these steps:
Step 1. If rack-mounted, slide the server out from the rack until it stops. (See "Extend the Server from the
Rack" on page 22.)
Step 2. Loosen the two captive thumbscrews that hold the top cover in place.
Step 3. Pull the cover toward the rear of the server to free the tabs from the slots in the center of the
chassis and lift the cover straight up.
30
Thumbscrews
Chapter 1