HP rp4410 Installation Manual page 67

Ensure that the system is powered off and all power sources have been
WARNING
disconnected from the server prior to attempting this procedure.
NOTE Some restrictions apply to the mass storage devices that can be connected to the core I/O SCSI
HBA. If you convert the server to duplex configuration, you cannot install external SCSI
devices to the SCSI HBA core I/O controller.
Accessing the SCSI Backplane
Before adding the accessories required to convert the server from simplex to duplex, you must remove outer
components to access the SCSI backplane. To gain access to the SCSI backplane, follow these steps:
Step 1. If rack-mounted, slide the server out from the rack until it stops. See "Extend the Server from the
Rack" on page 22.
NOTE
Step 2. Remove the front bezel. (See "Removing the Front Bezel" on page 28.)
Step 3. Remove the front cover. (See "Removing the Front Cover" on page 29.)
Step 4. Remove the memory extender board. (See "Removing a Memory Extender Board" on page 55.)
Step 5. Remove the processor extender board. (See "Removing the Processor Extender Board" on page 45.)
Convert to Duplex
To convert to duplex, follow these steps:
Step 1. Remove the SCSI jumper cable.
Chapter 1
If the server is pedestal-mounted, you need not remove the pedestal to perform the
simplex to duplex conversion. Proceed directly to the next step.
Installing the System
Installing Additional Components
67