Figure 1-19 Metal Cover In Unused Slot P1 - HP rp4410 Installation Manual

If the system is powered off, install the hot-swappable power supply into the server before
CAUTION
attaching the new power cord at the rear of the system. Failure to observe this caution results
in damage to the server.
To install a hot-swappable power supply, follow these steps:
Step 1. If rack-mounted, slide the server out from the rack until it stops. (See "Extend the Server from the
Rack" on page 22.)
Step 2. Remove the cable management arm from the rack slide nearest the power supplies. The cable
management arm does not need to be completely removed, but moved just enough to enable access
to the power supplies.
Step 3. Remove the metal cover from slot P1. Grasp the metal cover and pull straight out.

Figure 1-19 Metal Cover in Unused Slot P1

Step 4. Supporting the power supply with both hands, slide it into slot P1 until it plugs into the socket on
the internal power supply board. Hand tighten the thumbscrew.
Step 5. Install the power cord into the power supply socket and secure it to the power cord bracket.
Step 6. Apply power (200 - 240 VAC) to the new power supply. The LED immediately turns on.
Chapter 1
Installing the System
Installing Additional Components
41