Pen Tablet - Sony Ipela PCS-XG80 Integration Manual

Notes on monitor connections and settings
. When you wish to use an HDMI monitor, it must have a 1080i INPUT connection. A monitor without
the 1080i INPUT connection cannot display the menu.
. When you are using a 60-Hz monitor but the "Video1 → Frequency" is set to "50 Hz", the menu cannot
be displayed on the monitor and you cannot perform any menu operations.
In this case, access the Communication System by using a Web Browser and restore "Frequency" under
"Video:Basic" in the Setup Menu to "60 Hz".
Otherwise, restore the Frequency value to 60 Hz by connecting a serial cable to the AUX CONTROL port
on the rear of the Communication System and sending an external control command "setup save video
frequency-60 Hz".
. When "Video1 → Monitor Output" is set to "HDMI + RGB", the picture from the camera or PC con-
nected to the RGB IN terminal is displayed on the RGB monitor. If only the RGB monitor is connected,
you cannot perform any menu operations.
In this case, also connect an HDMI monitor.
If an HDMI monitor is not available, access the Communication System by using a Web Browser and
set "Monitor Output" under "Video:Basic" in the Setup Menu to "RGB".
Otherwise, restore the "Monitor Output" to "RGB" by connecting a serial cable to the AUX CONTROL port
on the rear of the Communication System and sending an external control command "setup save video
monout-rgb".

1-1-7. Pen Tablet

To use the function of Drawing and Pointing in communication, the pen tablet is needed.
To connect a Pen Tablet
1. Pen tablet is not a supplied accessories. So, prepare a pen tablet separately. About the pen tablet, refer
to the Notes as shown below.
2. Turn off the Communication System.
3. Connect the pen tablet to the TABLET connector on the front panel of the Communication System
before power-on.
4. Press the I/ (power) switch to turn on the Communication System.
m
. Supported TABLET model is only Wacom "Bamboo" (MTE450).
. The cable length which is attached by WACOM is 1.5 m (5 ft.).
. If you use another longer cable except the attached one or use USB Hub, verifi cation is needed before use.
PCS-XG80
To TABLET connector
1.5 m (5 ft.) (attached cable by Wacom)
Pen tablet
1-21