Sony Ipela PCS-XG80 Integration Manual page 50

"To set up video output" and "To set up video input" as shown below are not appeared in the Initial Setup
Wizard, but it is better to setup these settings fi rst according to your layout.
To set up video output
The Video setup menu is used to set up video output.
If you will connect PCS-XG80S with a single HDMI monitor, you need to select HDMI.
If you will connect PCS-XG80S with a single RGB monitor, you need to select RGB.
If you will connect PCS-XG80S with both HDMI monitor and RGB monitor, you need to select HDMI +
RGB.
HDMI + RGB is Dual Monitor Setup of previous model.
Main monitor should be HDMI and sub monitor should be RGB.
To set up Monitor output, "Setup → Video1 → Monitor Output".
Monitor Output allows you to select the video signal output from the Communication System.
HDMI: Outputs the video signal to the external equipment from the HDMI OUT connector.
RGB: Outputs the video signal to the external equipment from the RGB OUT connector.
HDMI + RGB: Outputs the video signal to the external equipment from the HDMI OUT and RGB OUT
connectors.
Do not select "HDMI + RGB" when a single RGB monitor is used, or the setup menu
will become unavailable.
Should this occur, refer to Section 1-1-6 "Notes on monitor connections and settings"
and then perform recovery.
2-4
PCS-XG80