Altos G5450 Installation Configuration Guide
After the driver is installed, run "aticonfig --initial" to configure the
6.
driver.
# aticonfig –initial
Uninitialised file found, Configuring.
Using /etc/X11/xorg.conf
Save back-up to /etc/X11/xorg.conf.original-0
Please reboot the system.
7.
If you want to change the display setting, please DO NOT use the OS
8.
built-in utility. Please use the ATI Catalyst Control Center instead by
"amdcccle" command.
# amdcccle
Gigabit Ethernet Driver Installation
1.
You can find the onboard NVIDIA nForce Networking Controller driver in
EasyBUILD 7.1 build 600. Please refer to Directory on EasyBUILD in Driver
Required section.
2.
After you insert the EasyBUILD 7.1 build 600 into the optical drive, it will
be mounted automatically. Please copy the driver from the EasyBUILD 7.1
build 600 to HDD first.
# cp /media/EBV71B600/Disk/g5450/nic/Nvidia/x64/sles10/nvlan-
sles10-0.60-1.21.x86_64.rpm /tmp
3.
Install the driver
# cd /tmp
# rpm –ivh nvlan-sles10-0.60-1.21.x86_64.rpm
RAID Utility Installation
You can find the MegaRAID Storage Manager for MegaRAID SAS 8708ELP
1.
in EasyBUILD 7.1 build 600. Please refer to Directory on EasyBUILD in
Software Required section.
After you insert the EasyBUILD 7.1 build 600 into the optical drive, it will
2.
be mounted automatically. Please copy the MegaRAID Storage Manager
from the EasyBUILD 7.1 build 600 to HDD first.
EBV71B600/
# cp –R /media/
Install MegaRAID Storage Manager
3.
# cd /tmp/
# ./install.sh
Type y to accept the license agreement and select 3 for StandAlone
4.
80
app/g5450/SAS/8708ELP/Linux/. /tmp