Xerox C2424 - WorkCentre Color Solid Ink User Manual page 173

Verifying Settings
1.
Verify the settings in the "Configuration Page."
■ IP Address Source is set to: DHCP, Front Panel, BOOTP, or Auto IP (depending
on your network configuration).
Current IP Address is set correctly. (Note this address if it is assigned by Auto IP,
■
DHCP, or BOOTP.)
■ Subnet Mask is set correctly (if used).
■ Default Gateway is set correctly (if used).
■ LPR is enabled. Verify that the LPR and AppSocket settings are set as desired.
■ Interpreters: Auto, PCL, or PostScript (depending on your driver).
2.
Verify that the client is logged into the network and printing to the correct print queue. The
user should also have access to the Phaser print queue.
Verifying Installation
1. Right-click the My Network Places icon on the desktop and select Properties.
2. Click the Protocols tab to verify that the TCP/IP protocol has been installed.
3. Click Add to install any components not listed, then restart your computer.
4. Click Start, click Settings, then click Control Panel.
5. Double-click Services.
6. Locate TCP/IP Print Server, then verify these column entries:
■ Status column: Started
■ Startup column: Automatic
7. Click Start, click Settings, then click Printers.
8. Right-click the printer icon, then select Properties. Verify that you have installed the
correct driver for your system.
9. Select the Ports tab. Verify that the IP Address in the Print to the Following Port list is
identical to the one on the "Configuration Page." You may need to click the Configure
Port button to view the IP address. If necessary, re-select the TCP/IP number used for
your system.
Printing a Test Page
1.
Click the General tab.
2.
Click Print Test Page. If the system still does not print, do one of the following:
■ Access PhaserSMART Technical Support on the Troubleshooting tab of your device
driver.
■ Go to www.xerox.com/office/support.
WorkCentre® C2424 Copier-Printer
6-23
Windows NT 4.x