Xerox C2424 - WorkCentre Color Solid Ink User Manual page 130

5. On the control panel:
a. Select Change, then press the Enter button.
b.
Select the paper size, then press the Enter button.
c. Select Special
6. In the printer driver, select Tray 1 as the paper source.
Note
Do not select Proof Prints during the print job. It will disturb the sequence of the
pre-collated sets.
7. To ensure the carbonless paper sets are properly loaded in the tray:
a. Print one complete set.
b.
Remove the set from the output tray.
c. Mark the top, white sheet of the printed set with a pen or a pencil.
If the paper is loaded correctly, the mark should appear on the printed side of the
■
subsequent colored sheets within a few seconds.
■ If a mark does not appear, repeat Steps 1–7 to make sure the paper is loaded correctly.
Printing Xerox Carbonless Paper from Tray 2, 3, or 4
1. Pull the tray completely out of the system.
for paper type, then press the Enter button to save your selection.
WorkCentre® C2424 Copier-Printer
5-45
Specialty Paper
2424-001