Dell 5110cn - Color Laser Printer User Manual page 164

Values:
Filter n Address
(n is 1 to 5.)
Mask
Mode Off*
Accept
Reject
NOTE: This item is only available for LPD or Port9100.
Reset MPC
Purpose:
To initialize NVRAM on the multi protocol card.
Adobe Protocol
Purpose:
To specify PostScript communication protocol for each interface. You can configure Adobe Protocol settings
for Network. The change becomes effective after the printer is turned off and then on again.
Values:
Used when auto-detecting the PostScript communication protocol.
Auto*
Used when the communication protocol is in ASCII interface.
Standard
Used when the communication protocol is in binary format.
BCP
Used when the communication protocol supports both ASCII and binary data to switch between
TBCP
them according to the specified control code.
Used when no special processing is required.
Binary
Sets the IP address for Filter n.
Sets the mask for Filter n.
Disable the IP Filter feature for Filter n.
Accepts an access from specified IP address.
Rejects an access from specified IP address.