Dell 5110cn - Color Laser Printer User Manual page 161

IP Address
Subnet Mask
Gateway Address
Reset
2
IPsec*
1
* Only displayed when an optional multi-protocol card is installed on the printer.
2
* Only displayed when IPsec is enabled.
3
* This mode is available only when firmware version 200705311932 or later and network (MPC) firmware
version 16.03 or later are installed. Since you cannot set IPsec in Windows Vista in this mode, use the Dell
Printer Configuration Web Tool. The Get Information from Printer function on the Options tab of the
printer driver is not available when using this mode.
Protocol
Purpose:
To enable or disable each item. The change becomes effective after the printer is turned off and then on
again.
Values:
LPD
Port9100
1
IPP*
* 1
SMB TCP/IP
Sets the IP address allocated to the printer by using the keys on the
operator panel.
Sets the subnet mask.
Sets the gateway address.
Disables IPsec.
Enables the LPD port.
Enable*
Disables the LPD port.
Disable
Enables the Port9100 port.
Enable*
Disables the Port9100 port.
Disable
Enables the IPP port.
Enable*
Disables the IPP port.
Disable
Uses TCP/IP for SMB.
Enable*
Does not use TCP/IP for SSB.
Disable