Electronic Emission Statements; Federal Communications Commission (Fcc) Statement; Industry Canada Compliance Statement; European Community Compliance Statement - IBM 2109 - SAN Fibre Channel Switch Model S16 Service Manual

San fibre channel switch
Table of Contents

Advertisement

UNIX is a registered trademark of The Open Group in the United States and other
countries.
Other company, product, or service names may be trademarks or service marks of
others.

Electronic emission statements

This section gives the electronic emission notices or statements for the United
States and other countries.

Federal Communications Commission (FCC) statement

This equipment has been tested and found to comply with the limits for a class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful
interference, in which case the user will be required to correct the interference at
his own expense.
Properly shielded and grounded cables and connectors must be used in order to
meet FCC emission limits. IBM is not responsible for any radio or television
interference caused by using other than recommended cables and connectors or by
unauthorized changes or modifications to this equipment. Unauthorized changes or
modifications could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.

Industry Canada compliance statement

Avis de conformite a la reglementation d'Industrie Canada: Cet appareil
numerique de la classe A est conform a la norme NMB-003 du Canada.

European Community compliance statement

This product is in conformity with the protection requirements of EC Council
Directive 89/336/EEC on the approximation of the laws of the Member States
relating to electromagnetic compatibility. IBM cannot accept responsibility for any
failure to satisfy the protection requirements resulting from a non-recommended
modification of the product, including the fitting of non-IBM option cards.
This product has been tested and found to comply with the limits for class A
Information Technology Equipment according to European Standard EN 55022. The
limits for class A equipment were derived for commercial and industrial
environments to provide reasonable protection against interference with licensed
communication equipment.
Attention:
cause radio interference in which case the user may be required to take adequate
measures.
132
IBM SAN Fibre Channel Switch: 2109 Model S16 Installation and Service Guide
This is a class A product. In a domestic environment, this product may

Advertisement

Table of Contents
loading

This manual is also suitable for:

2109 s16

Table of Contents