Error Messages - Dell E80S Series Installation And Service Manual

Table 7. Configuration validation error (continued)
Error Description
Comm Error A configuration element is not responding
to iDRAC using the management interface
while running an inventory check.

Error messages

This section describes the error messages displayed on the screen during POST or captured in the system event log (SEL)/
LifeCycle (LC) log.
Table 8. Error message HWC8010
Error code HWC8010
Message The System Configuration Check operation resulted in the following issue involving the indicated
component type
Arguments floating card (adapter PERClike BOSS), backplane, processor, cable, or other components
Detailed Description The issue identified in the message is observed in the System Configuration Check operation.
Recommended Do the following and retry the operation:
Response Action
1. Disconnect the input power.
2. Check for proper cable connection and component placement. If the issue persists, contact the
Category System Health (HWC = Hardware Config)
Severity Critical
Trap/EventID 2329
Table 9. Error message HWC8011
Error code HWC8011
Message The System Configuration Check operation resulted in multiple issues involving the indicated component
type
Arguments floating card (adapter PERClike BOSS), backplane, processor, cable, or other components
Detailed Description Multiple issues are observed in the System Configuration Check operation.
Recommended Do the following and retry the operation:
Response Action
1. Disconnect the input power.
2. Check for proper cable connection and component placement. If the issue persists, contact the
Category System Health (HWC = Hardware Config)
Severity Critical
20 Minimum to POST and system management configuration validation
service provider.
service provider.
Possible cause and
recommendations
System management
sideband communication
Unplug AC Power, reseat
the element and replace
the element if the problem
persists.
Example
Comm Error: Backplane 2