Cisco QuickVPN - PC Administration Manual page 180

Gateway-to-Gateway VPN Tunnel
Configuration When Both Gateways Use Dynamic IP Addresses
STEP 1
Cisco RVS4000 4-Port Gigabit Security Router with VPN Administration Guide
Gateway-to-Gateway IPSec VPN Tunnel - Both Gateways Using
Dynamic IP
Each computer must have a network adapter installed.
NOTE
Configuration of the RVS4000.
Follow these instructions for the first VPN router, designated RVS4000. The other
VPN router is designated the RV082.
a. Launch the web browser for a networked computer, designated PC 1.
b. Access the web-based utility of the RVS4000. (Refer to
and Configuring the Router"
c. Click VPN > IPSec VPN.
d. Enter a name in the Tunnel Name field.
e. For the IPSec VPN Tunnel setting, select Enable.
f. The WAN IP address (A.A.A.A) of the RVS4000 will be automatically detected.
For the Local Security Group Type, select Subnet. Enter the RVS4000's local
network settings in the IP Address and Subnet Mask fields.
for details.)
D
Chapter 5, "Setting Up
173