Setup > Time - Cisco QuickVPN - PC Administration Manual

Setting Up and Configuring the Router
Setup
Cisco RVS4000 4-Port Gigabit Security Router with VPN Administration Guide
Hop Count This value gives the number of nodes that a data packet passes
through before reaching its destination. A node is any device on the network, such
as switches, PCs, etc. The maximum hop count value is 16.
Show Routing Table
through dynamic or static routing methods.
Inter-VLAN Routing
Inter-VLAN Routing Select Enable to allow packets to be routed between VLANs
that are in different subnets. The default is Enable.
Click Save Settings to save the Routing settings or click Cancel Changes to undo
your changes.
Setup > Time
Setup > Time
Set the local time Manually
this option, then select the Date from the drop-down fields and enter the hour,
minutes, and seconds in the Time fields using 24-hour format. For example, for
10:00 pm, enter 22 in the hours field, 0 in the minutes field, and 0 in the seconds
field.
Set the local time using Network Time Protocol (NTP) Automatically
to use a Network Time Protocol server to set the time and date, select this option,
then complete the following fields.
Time Zone Select the time zone for your location and your time setting is
synchronized over the Internet.
Auto Daylight Saving
Enable option.
Click this button to show the routing table established either
If you wish to enter the time and date manually, select
If your location observes daylight savings time, select the
5
If you wish
43