Cisco QuickVPN - PC Administration Manual page 67

4-port gigabit security router with vpn
Hide thumbs Also See for QuickVPN - PC:
Table of Contents

Advertisement

Setting Up and Configuring the Router
VPN
Cisco RVS4000 4-Port Gigabit Security Router with VPN Administration Guide
IPSec VPN Tunnel
Check the Enable option to enable this tunnel.
Tunnel Name
Enter a name for this tunnel, such as "Anaheim Office".
Local Group Setup
Local Security Gateway Type
Name (FQDN) Authentication.
IP Only If this is selected, the RVS4000's WAN IP address automatically
appears in the IP Address field.
IP + Domain Name (FQDN) Authentication This is the same as IP Only, but
includes a domain name for greater security. Enter an arbitrary domain
name in the Domain Name field. The router's WAN IP address automatically
appears in the IP Address field.
Local Security Group Type
use this VPN tunnel. This may be a single IP address or Sub-network. Notice that
the Local Security Group Type must match the other router's Remote Security
Group Type.
IP Address
Enter the IP address on the local network.
Subnet Mask
If the Local Security Group Type is set to Subnet, enter the mask to
determine the IP addresses on the local network.
Remote Group Setup
Remote Security Gateway Type Select either IP Only or IP + Domain Name
(FQDN) Authentication. The setting should match the Local Security Gateway
Type for the VPN device at the other end of the tunnel.
IP Only Select this to specify the remote device that will have access to the
tunnel. Then either select IP Address from the drop-down menu and enter
the remote gateway's WAN IP address in the IP Address field, or select IP
by DNS Resolved from the drop-down menu and enter the remote
gateway's domain name in the Domain Name field.
IP + Domain Name (FQDN) Authentication This is the same as IP Only but
includes a domain name for greater security. Enter an arbitrary domain
name in the Domain Name field. Then select either IP Address or IP by
DNS Resolved from the drop-down menu, and fill in the IP Address field or
Domain Name field.
This has two settings, IP Only and IP + Domain
Select the local LAN user(s) behind the router that can
5
60

Advertisement

Table of Contents
loading

This manual is also suitable for:

Small business rvs4000

Table of Contents