Configuration When Both Gateways Use Dynamic Ip Addresses - Cisco QuickVPN - PC Administration Manual

Gateway-to-Gateway VPN Tunnel

Configuration When Both Gateways Use Dynamic IP Addresses

STEP 3
Configuration When Both Gateways Use Dynamic IP
Addresses
Cisco RVS4000 4-Port Gigabit Security Router with VPN Administration Guide
RV082 IPSec Setup Settings
l. If you need more detailed settings, click Advanced Settings. Otherwise, click
Save Settings.
Configuration of PC 1 and PC 2.
Verify that PC 1 and PC 2 can ping each other (refer to Windows Help for more
information). If the computers can ping each other, then you know the VPN tunnel is
configured correctly.
This example assumes both Gateways are using dynamic IP addresses. If only the
Remote Gateway uses a dynamic IP address, refer to
Remote Gateway Uses a Dynamic IP Address," on
"Configuration when the
page167.
D
172