Right-Side/Rear View; Operation Panel - Brother 882-T52 Operation Manual

Right-side/rear view

1 Touch pen holder
Use the touch pen holder to hold the touch pen when not in
use.
2 USB port (USB 2.0)
In order to send patterns from/to USB media, plug the USB
media directly into the USB port.
3 USB port for computer
In order to import/export patterns between a computer and the
machine, plug the USB cable into the USB port.
IMPORTANT
• Do not insert anything other than a USB flash
drive into the USB port. Anything else may
damage the machine.
4 LCD panel angle button
Press to change the angle of the operation panel. Do not
change the angle without pressing this button.
5 Power cord receptacle
Insert the plug on the power supply cord into the power supply
plug.
6 Main power switch
Use the main power switch to turn the machine ON (I) and OFF
(O). Do not turn the power on soon after turning the power off.
It is recommended that you wait 5 seconds before turning the
power back on.
7 Handwheel
Rotate the handwheel to move the needle up and down. Be
sure to rotate the handwheel toward the operation panel.
8 Ventilation slots
The ventilation slots allow the air surrounding the motor to
circulate. Do not cover the ventilation slots while the machine is
being used.

Operation panel

1 2
1 "Start/Stop" button
Press the "Start/Stop" button to start or stop the machine. The
lighting status and color of the button changes depending on
the operation condition of the machine.
Lit in red : When the machine cannot start
embroidering
Flashing in green : When the machine can start
embroidering
Lit in green : While the machine is embroidering
Off : When the machine is turned off
2 Thread trimming button
Press the thread trimming button to trim both the upper and
the bobbin threads.
3 Automatic needle-threading button
Press the automatic needle-threading button to thread the
needle.
4 Speaker
5 LCD (touch panel)
Touch the keys that appear on the touch panel to select and
edit patterns and confirm various information.
3 4 5
11