Tools For Checking Array State & Status - HP StorageWorks 7110 - Virtual Array Service Manual

Tools for Checking Array State & Status
CommandView SDM GUI
1 The array state is displayed with an icon in the upper left-hand corner
(banner area) of the screen.
2 Click on the "Status" tab. Click on "Array Status" and view the "Overall
Array State" and "Warning States". Click the Help button for a description
of the problem and solution for "Warning States". Click on "Component
Status" then click on a component in the "Selected Enclosure" box on the
left-hand side to display the status of any array component. Click the Help
button for a description of the status for each component.
3 Click on the "Diagnostics" tab. Click on "Array" to display the same
information as "Array Status" under the "Status" tab. Click on "Disk" then
click on "Condition" to display the status of the disks in the array. Click on
"State" to see if the disks are currently included or not included.
CommandView SDM CLUI
1 Use the "armdsp -a" command to display the Array State messages and
detailed information about the FRUs in the array.
2 Use the "armdsp -f" command to quickly display any FRU Status messages.
CommandView SDM CVUI
1 Select "Storage->HpArrayMain->Properties->Config&Status" to display the
Array State messages and detailed information about the FRUs in the
array.
2 Select "Storage->HpArrayMain->Properties->Components" to quickly
display any FRU Status messages.
VFP
1 Use the "vfpdsp" command to display the Array State messages and
detailed information about the FRUs in the array.
2 Use the "vfpdsp -f" command to quickly display any FRU Status messages.
Troubleshooting 85