HP StorageWorks 7110 - Virtual Array Service Manual page 146

146 Specifications & Regulatory Statements
— UL 60950-2000
Electrical Safety
WARNING
— The product power cords are used as main disconnect devices. To
ensure that the power cords can be disconnected quickly, locate the
product near an easily accessible power outlet.
— Use only UL/CSA approved power cords, SVT type, rated for a suitable
voltage and current. These power cords have two conductors and a
ground. Failure to use the proper power cord may result in an electric
shock or fire hazard.
— To avoid a fire hazard, the ac branch service must be properly current-
protected by either a fuse or a circuit breaker. Hewlett-Packard
recommends the use of magnetic-type circuit breakers, which are
capable of handling large inrush currents for short durations (10-12
ms) and are rated adequately for the steady state currents. Also, make
sure all equipment is properly grounded.
Class 1 Laser Safety Statement
A. Certification and Classification Information
This product contains a laser internal to the Small Form Factor (SSF) module for
connection to the fiber communications port.
In the USA, the SSF module is certified as a Class 1 laser product conforming
to the requirements contained in the Department of Health and Human
Services (DHHS) regulation 21 CFR, Subchapter J. The certification is indicated
by a label on the metallic SSF housing.
Outside the USA, the SSF is certified as a Class 1 laser product conforming to
the requirements contained in IEC 825-1:1993 and EN 60825-1:1994,
including Amendment 11:1996.
The SSF includes the following certifications:
* CSA Certified Component (Canada & US)
* TUV Certified Component (European Union)
The following figure shows the Class 1 information label that appears on the
metal cover of the SSF housing: