Operating The Power/Standby Switch - HP StorageWorks 7110 - Virtual Array Service Manual
Hp storageworks virtual array 7000 family user and service guide (january 2005)
Hide thumbs
Also See for StorageWorks 7110 - Virtual Array:
- Using manual (34 pages) ,
- Upgrade instructions (12 pages) ,
- Instructions (4 pages)
Table of Contents
Advertisement
Operating the Power/Standby Switch
Figure 11
Operating the Power/Standby Switch
When the power/standby switch is in the "power" position, ac power is
applied to the primary and secondary sides of the power supplies in the power
module and all of the dc circuits in the array are active. When the power/
standby switch is in the "standby" position, ac power is only applied to the
primary side of the power supplies; all of the dc circuits in the array are
disabled.
To switch power on, push in the power/standby switch to the "power" position.
See
Figure
11.To switch power to standby, push in the power/standby switch
then release it to the "standby" position.
Caution
If it is necessary to completely remove power from the array, you
must unplug both power cords from the ac power connectors on
the array rear panel.
Product Overview
35
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the StorageWorks 7110 - Virtual Array and is the answer not in the manual?
Questions and answers