HP StorageWorks 7110 - Virtual Array Service Manual page 110

Hp storageworks virtual array 7000 family user and service guide (january 2005)
Hide thumbs Also See for StorageWorks 7110 - Virtual Array:
Table of Contents

Advertisement

110 Servicing & Upgrading
If a DIMM failure did not occur:
a
Remove the battery from the removed array controller. See
an Array Controller Battery" on page
b
Remove the DIMMs from the removed array controller. See
an Array Controller DIMM" on page
Installing an Array Controller
(HP Service Personnel Only)
Caution
If the green BATTERY LED is flashing and you remove a DIMM,
damage to the array controller or DIMM may occur.
Do not use a controller that has HP14 firmware as a replacement
if the remaining controller has an earlier version of firmware.
Earlier versions of firmware cannot overwrite HP14 firmware.
Replacement controllers ordered from HP have HP13 or earlier
firmware on them. If you are unsure of the firmware version on
the controller, do not use it as a replacement.
1
If the green BATTERY LED on the new or upgrade array controller is off, go
to step 2. If the green BATTERY LED on the new or upgrade array controller
is flashing with a 5% duty cycle (battery fully charged), disconnect the
battery from the battery terminal. See
Battery" on page
117. Reconnect it and verify that the green BATTERY LED
is off.
Note
Disconnecting the battery from the array controller resets a bit
on the controller which disables battery power to the DIMMs.
2
Either install new DIMMs (ordered separately) on the new array controller
or transfer functional DIMMs from the old controller. See
Array Controller DIMM" on page
3
VA 7100 only: Slide the latch
4
VA 7100: Press down the lock
VA 7110/7400/7410: Pull out the cam lever
5
Grasp the edges of the array controller with both hands and push it firmly
into the slot.
(Figure 43
6
Push in the cam lever
7
VA 7100 only: Slide the latch
117.
120.
"Removing an Array Controller
120.
(Figure
43, 1) all the way to the left.
(Figure
43, 2) and pull out the cam lever (3).
or
Figure
44).
(Figure
43, 3 or
Figure
(Figure
43, 1) all the way to the right.
"Removing
"Removing
"Installing an
(Figure
44, 2).
44, 2) until it clicks into place.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Storageworks 7410 - virtual array

Table of Contents