Netware 5 Requirements - HP D7171A - NetServer - LPr User Manual

Chapter 2

NetWare 5 Requirements

The PCI Hot Plug feature is operational in all ten slots, if:
The NetWare's Hot Plug Controller driver (phpsbd.nlm) is loaded.
The PCI Hot Plug board has a driver loaded or a drive for loading.
The Hot Plug feature must be loaded before the Hot Plug feature can be
enabled. If you selected Express or Guided Setup, all the NetWare
Loadable Modules (NLMs) were installed onto the system, along with the
correct drivers.
The proper PCI Hot Plug Controller Driver is phpsbd.nlm, version 1.10 (or
greater). During Express installation, the controller driver, phpsbd.nlm, is
automatically installed on the HP NetServer from the HP Navigator CD.
If you choose Custom, you may not have loaded the correct drivers
(NLMs). When performing a manual install, it is necessary to obtain the
phpsbd.nlm driver from the Navigator CD and copy it into the system
directory. This file can be obtained from the Navigator diskette library
"PCI Hot Plug for NetWare 5". In either case, ensure you load it prior to
running the NetWare 5.0 Hot Plug user interface (ncmcon.nlm) or
performing any Hot Plug operations.
PCI Hot Plug Utility for Novell NetWare
Figure 14. Main User Interface Screen
19