HP D7171A - NetServer - LPr User Manual page 37

Chapter 2
PCI Hot Plug
LED Indicators
P10
Table 7 decodes the LEDs for each PCI slot:
Table 7. PCI (Hot Plug) LED Codes (rear panel view)
Amber Green Slot
LED LED Status
Off On Ready
Powered On The PCI slot just power on, but the driver initiation is
Active
On Off Powered
Off (wrong
board or no
board)
PCI Hot Plug Utility for Novell NetWare
Attention
(Amber)
P9 P8 P7 P6 P5 P4
Figure 24. Hot Plug Slots and LEDs
Indicates This Status
Powered on, but no driver loaded for board. Do not
remove the board from the slot.
not complete yet. This only happens momentarily prior
to completing driver loading. Do not remove the board
from the slot.
Power to the slot is on, and the slot is operating
normally. Do not remove the board from the slot.
Power to the slot is off, but the Amber LED is on, due
to a failure in the Hot Replacement process. Typically
this is the result of installing the wrong board, because
the replacement board must be the same type as the
original PCI board. This also occurs if the board is
removed, emptying the slot, and power is turned on.
You can safely remove the board from this slot.
Power
P3 P2 P1
33