HP D7171A - NetServer - LPr User Manual page 38

Pci hot plug utility
Hide thumbs Also See for D7171A - NetServer - LPr:
Table of Contents

Advertisement

Appendix B
Amber
Green
Slot
LED
LED
Status
Off
Off
Powered
Off
5. If not, go back to the software interface NCMCON and verify you have
turned off power to the correct slot.
6. If you are unable to power down the slot, remove and install a PCI board in
the Hot Plug slot as described in your Installation Guide.
7. Do not continue with this procedure, if you are unable to power down the
desired PCI slot.
CAUTION
To prevent a system crash or hang do not open the PCI hold-
down latch, if you are unable to turn off power to the PCI slot,
using the software interface (NCMCON).
8. Press the PCI hold-down latch to release the PCI board in the slot. See
Figure 25.
A. Push here
Figure 25. Opening the PCI Hold-Down Latch
34
Warranty, Software License and Support
Indicates This Status
Power to the slot is off. You can safely remove the
board from this slot.
B. Pull latch
to half open from rear.
to release
(should click).

Advertisement

Table of Contents
loading

Table of Contents