HP D7171A - NetServer - LPr User Manual page 42

Appendix B
Ensure
PCI hold-down
latch is at least half open
before inserting board.
Figure 28. Installing the Accessory Board
7. Close the PCI hold-down latch, by pushing it in from the rear of the
NetServer, until it clicks. See Figure 29.
The PCI hold-down latch should click when you push it into place.
8. Close the latch on the PCI board guide. See Figure 29.
9. If the installed accessory board requires an external connection, or a
connection to the I/O baseboard, ensure the cable is properly attached.
Refer to the accessory board documentation for connection requirements.
38
Warranty, Software License and Support
Insert board