HP D7171A - NetServer - LPr User Manual page 7

Chapter 1
3. If no hot plug support appears under Board in the Utility's window
instead of the desired PCI board, one of the following conditions might be
true:
à
The PCI Hot Plug board is not supported by a hot plug compliant
software driver.
à
The software driver for the PCI Hot Plug board is not properly installed
and loaded.
See Windows NT Help for how to load drivers.
à
The PCI board may not use a driver, or the driver is defective.
NOTE
If you have a board without a hot plug compliant driver in one
of the hot plug slots, the board will show up in the Utility as no
hot plug support, and the Utility will not allow you to power
down the slot.
4. Identify the physical location of the desired PCI Hot Plug board, using the
PCI Hot Plug Utility and Figures 2 and 3.
PCI Hot Plug Utility for Microsoft Windows NT
Figure 1. PCI Hot Plug Utility
3