HP D7171A - NetServer - LPr User Manual page 20

Chapter 1
The right Power LED on the rear panel LED display should be green and
the left Attention LED should be off (gray) at this point.
8. If possible, verify the PCI board's operation, before continuing.
9. If you are assured of the PCI board's operation, including its driver,
continue with the next step.
10. If all desired PCI Hot Plug boards have been installed, replace the PCI
access panel.
Refer to the section "Removing the PCI Access Panel" in your Installation
Guide.
NOTE
The PCI access panel uses the only short T-15 Torx
the HP NetServer, to prevent the top cover from catching on
the center support, when it is removed with the PCI access
panel in place.
CAUTION To prevent damage to cables, or a disruption in service due to
a disconnection of cables, use caution when sliding the chassis
into the rack, if not using the Cable Management Arm.
11. If chassis work is complete, slide the HP NetServer chassis back into the
rack (refer to your Installation Guide).
12. Return the HP NetServer to normal operation (refer to your Installation
Guide).
16
Server Administration Using HP TopTools
®
screws on