Replace Power Supply Modules And Hard Disk Drives - HP D7171A - NetServer - LPr Manual

Chapter 3
10. Plug the HP NetServer's power cable and all available data cables into the
back of the HP NetServer.
Replace Power Supply Modules and Hard Disk
Drives
Do the following to replace the power supply modules and hot-swap hard disk
drive modules:
1. Refer to the NetServer's user guide or installation guide to replace the
power supply modules in the power supply cage. Ensure that the modules
are seated correctly, and then fasten the thumbscrews.
2. Refer to the NetServer's user guide or installation guide to replace the hard
disk drive modules in the hot-swap mass storage cage. Make sure the
locking pin engages the cage lip and secures the module in position.
Conversion: Install Components, Cover, and Front Bezel
31