Prepare For Installation - HP D7171A - NetServer - LPr Manual

Chapter 1
The assembly kit for HP racks includes the following hardware:
Front bezel for the NetServer in the HP rack configuration
Bezel hinge plate and bezel hinge for the HP rack configuration
Rack chassis retention bracket for the HP rack
Mounting screws and hardware for the items listed above
Two HP NetServer LH 3r rack installation templates
Two HP NetServer LH 4r rack installation templates
Two HP NetServer LH 3000r and LH 6000r rack installation templates
The assembly kit for Compaq racks includes the following hardware:
Front bezel for the NetServer in the Compaq rack
Left and right recessed brackets for the Compaq rack configuration
Mounting screws and hardware for the items listed above
HP NetServer LH 3, LH 4r, LH 3000r, and LH 6000r Installation
Guide for Compaq

Prepare for Installation

Gather the tools and the setup information you need before beginning the
conversion. Place the NetServer where there will be sufficient space to remove the
covers, power supply modules, and disk drives. If you plan to add accessory
boards or additional memory, reserve bench space at a comfortable level so you
can reach the interior of the NetServer easily.
®
4000/7000 Racks
Introduction
7