HP D7171A - NetServer - LPr Manual page 38

Chapter 3
2. Secure the nameplate to the front bezel, as follows:
For the HP rack front bezel, insert the tab at one end of the nameplate
into the slot in the bezel, bend the nameplate slightly, and
simultaneously insert the snaps on the back of the nameplate and the tab
at the other end of the nameplate.
For the Compaq rack front bezel, insert the snap at one end of the
nameplate, and then insert the other snaps successively.
The conversion kit contains two processor labels:
Label reading "intel inside
Label reading "intel inside pentium II xeon" is for the HP NetServer LH 4r.
Label reading "intel inside
LH 3000r and LH 6000r.
3. Attach the appropriate label to a convenient location near a corner of the
front bezel.
34
Conversion: Install Components, Cover, and Front Bezel
®
pentium II" is for the HP NetServer LH 3r.
®
pentium III xeon" is for the HP NetServer