Replacing The Disk Enclosure I/O Module; Replacing The Disk Enclosure Power Supply; Replacing The Disk Enclosure Fan - HP P4800 G2 Maintenance Manual

Replacing the disk enclosure I/O module

This section describes how to remove and replace the disk enclosure I/O module on the HP P4800
G2 solution.
CAUTION:
procedures to shut down the management group in the CMC Online Help or HP P4000 SAN
Solution User Guide. In addition, be sure the hard drive drawer is closed completely before
removing or replacing the disk enclosure I/O module.
CAUTION:
To remove the component:
1. Disconnect the SAS cables, and release the I/O handle.
2. Push the I/O handle down to unlatch the I/O module.
3. Remove the I/O module.
Figure 9 Removal of the I/O module
CAUTION:
more than one component or blank removed. When removing an active component, replace it
with a blank.
To replace the I/O module, reverse the removal procedure.

Replacing the disk enclosure power supply

There are four power supplies in each disk enclosure chassis—two on the left and two on the right.
The system can operate with a single power supply on the left and a single power supply on the
right.
1. Remove a power cable.
2. Remove the power supply unit.
3. Insert a new power supply unit.
4. Reattach the power cable.

Replacing the disk enclosure fan

There are four fans in each disk enclosure chassis. The system can operate for a short period with
one fan removed.
NOTE: The disk enclosure drawer must be closed while you replace the fan module.
26 Removing and replacing the HP P4800 G2 solution components
Before replacing the I/O module, be sure to power down the server blades using the
Power down the disk enclosure before disconnecting a SAS cable.
For best cooling practices, do not operate the enclosure for extended periods with