Replacing The Power Supply Modules And Hard Disk Drives - HP D7171A - NetServer - LPr Manual

Chapter 3
Figure 3-4. Reattaching the Control Panel Bezel
Replacing the Power Supply Modules and Hard
Disk Drives
1. Refer to Figure 2-4 and replace the power supply modules in the power
supply cage. Make sure the modules are seated correctly and fasten the
thumbscrews.
2. Refer to Figure 2-3 and replace the hard disk drive modules in the
hot-swap mass storage cage. Make sure the locking pin engages the cage
lip and secures the module in position.
3. Install the bezel for the HP rack version or the Compaq rack version. The
installation is complete.
Installing LH 3r Components
17