Removing Or Installing A 2-Port Ethernet Iscsi Blank; Before You Begin; Removing A 2-Port Ethernet Iscsi Blank; Installing A 2-Port Ethernet Iscsi Blank - HP StorageWorks 1510i - Modular Smart Array Service Manual

Hp storageworks 1510i modular smart array maintenance and service guide (383072-002, july 2008)

Hide thumbs Also See for StorageWorks 1510i - Modular Smart Array:

Table of Contents

Removing or installing a 2-Port Ethernet iSCSI blank

CAUTION:

•

Before removing a component or blank from an operational device, make sure that you have the

replacement part or blank available. Removing a component or blank impacts the airﬂow pattern

and cooling ability of the device. Allow approximately 30 seconds before installing the new or

replacement component to ensure that conﬁguration data about the removed component is cleared

from the system registry, but, to avoid possible overheating, insert the new or replacement component

within one or two minutes. If the internal temperature exceeds acceptable limits, the device may

overheat and automatically shut down or restart.

•

Parts can be damaged by electrostatic discharge. Use proper anti-static protection.

Lift the port-colored module latch (1) and pull the module out of the chassis (2).

Slide the blank into the MSA chassis bay until the blank clicks into place.

newpage pi

Customer replaceable components

Table of Contents