HP StorageWorks P9000 Software Installation Manual page 39

YKLCNS2=[prefix2] ~ <8 or fewer
alphanumeric characters>
LOGPUT=[LOGR | SAM]
SYSLOG=[YES | NO]
Specify a prefix2 for the license
information dataset so that the name of
the dataset is unique. If the prefix2 is
omitted, specify PARM='YKLCNS2='.
For details about the prefix2 for the
license information dataset, see section
"Naming Conventions for License
Information Datasets" (page
Specify whether or not the system logger service
is to be used, when outputting BCM logs.
The specified value for the LOGPUT parameter is
given priority over the &YKLOGPT system symbol
in the IEASYMxx parmlib member. If this
command is executed with the LOGPUT parameter
omitted (PARM='LOGPUT=' is specified), the
value of the &YKLOGPT system symbol will be
used.
LOGR: BCM logs are output using the system
logger service.
SAM: BCM logs are output to sequential datasets.
Specify whether or not CLI command-execution logs
are output to SYSLOG.
The value specified for the SYSLOG parameter is
given priority over the &YKSYSLG system symbol in
the IEASYMxx parmlib member. If this command is
executed with the SYSLOG parameter omitted
(PARM='SYSLOG=' is specified), the value of the
&YKSYSLG system symbol will be used.
YES: CLI command-execution logs are output to
SYSLOG.
NO: CLI command-execution logs are not output to
SYSLOG.
For details about commands that collect CLI
command-execution logs, see the Hitachi
Business Continuity Manager User Guide.
Installing Business Continuity Manager
44).
39