Cf_Nzred Command; Cf_Image Command; Cf_Imageadj Command - Sanyo PLC-XL50A - 2000 Lumens Manual

PLC-XL50 Expand Serial Command Functional Specifications

8.4.10 CF_NZRED Command

Command "CF_NZRED_%1"[CR]
"OFF" ------- Cancel Noise Reduction
%1 "L1" --------- Noise Reduction for moving image
"L2" --------- Noise Reduction for still image
Set Noise Reduction of User control
The value set by this command will not be saved to the projector. Therefore, when
Details ALL is OFF, the value returns to the original setting (The value is held in Suspend
mode)
This command is available in the normal Power ON status.
Acceptable
Response
Unacceptable

8.4.11 CF_IMAGE Command

Command "CF_IMAGE_%1"[CR]
"DYNAMIC" ------ Dynamic (Fixed value to enable projection with a sharp, powerful
"STAND" ---------- Standard (Image adjust value is set to factory default)
"REAL" ------------ Real (Fixed value to display graphic image with natural tone)
"CINEMA" -------- Cinema (Fixed value to focus on tone reproduction for movie)
"BLACKBOARD" – Blackboard (Fixed value to project image onto grren-colored
%1
"COLORBOARD " – Colorboard(Fixed value to project image onto colored board)
"CUSTOM1" ----- Image1 (the value set and stored by a user)
"CUSTOM2" ----- Image2 (the value set and stored by a user)
"CUSTOM3" ----- Image3 (the value set and stored by a user)
"CUSTOM4" ----- Image4 (the value set and stored by a user)
Select Image Mode (Available only in the normal Power ON status)
Parameter "CUSTOM1" to "CUSTOM4" is the same as "Image1" to "Image4"
Details displayed when selecting Image on OSD menu.
The value set by this command is stored in EEPROM and its setting is effective
even after ALL is OFF.
Acceptable
Response
Unacceptable

8.4.12 CF_IMAGEADJ Command

Command "CF_IMAGEADJ_%1"[CR]
"RST" ------- Reset Image adjustment
"STR1" ----- Store current Image adjustment to Image 1
%1 "STR2" ----- Store current Image adjustment to Image 2
"STR3" ----- Store current Image adjustment to Image 3
"STR4" ----- Store current Image adjustment to Image 4
Reset / store Image adjustment.
(Available only in the normal Power ON statement)
Parameter "STR1" to "STR4" is the same as "Image1" to "Image4" displayed when
Details
adjusting Image on OSD menu and selecting "Store"
The value stored to "Image1-4" is saved and its setting is effective even after ALL
is OFF.
Acceptable
Response
Unacceptable
"000"[CR]
"Error Code"[CR]
picture tone)
blackboard)
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
18/51