Others - Kubota G21LD / G21HD Workshop Manual

G21LD · G21HD, WSM

[13] OTHERS

Replacing Fuses
1. The electrical system is protected from potential damage by
fuses.
A blown fuse indicates that there is an overload or short
somewhere in the electrical system.
2. If any of the fuses should blow, replace with a new one of the
same capacity.
IMPORTANT
• Before replacing a blown fuse, determine why the fuse blew
and make any necessary repairs.
procedure may result in serious damage to the electrical
system.
Protected Circuit
FUSE NO.
(ID LABEL)
(a) EPS MT
1 (b) E/G STOP
(c) IG/M
2 – Slow blow fuse 40
(1) Fuse
Replacing Bulbs
(A) Replacing the head light bulb
1. Open hood.
2. Turn bulb socket to remove socket from headlight housing.
3. Push bulb down and turn one quarter turn to remove bulb from
the socket.
4. Install new bulb to the socket.
5. Install the socket in housing.
6. Close hood.
Head light bulb Capacity
(B) Replacing the indicator light bulb
1. Open hood.
2. Turn bad bulb socket to the left and remove it.
3. Pull bulb from the socket.
4. Push new bulb into the socket.
5. Install the socket.
6. Close hood.
Indicator light bulb Capacity
G-43
Failure to follow this
CAPACITY
Protected circuit
(A)
Electric power steering moter
30
circuit
15 Engine stop timer relay
Fuel pump, head light, power
10
steering control unit, etc.
Check circuit against wrong
battery connection
(2) Slow Blow Fuse
1.04A / 12.8 Rated
voltage
0.27A / 14.0 Rated
voltage
KiSC issued 08, 2007 A
G GENERAL